Chosen Solution
After replacing the screen assembly, this error is happening. The phone will turn on, but it won’t charge. The above message comes up. This is the second time this has happened after replacing the screen. Please help. What am I doing wrong, and how can I fix it?
It turns out the charger port flex was damaged in some way during the screen replacement. This is the usual cause of this message. Thanks.
== Any kind of temperature errors at any kind of mobiles: galaxy, nokia, iphone ,etc often caused by the line of battery temperature(btemp/ at nokia ) (ntc / at iphone ), so , we have first to change charger and also change battery and check battery connector befor we check this battery temperature line to remove capacetors and similar components and to check if the serial elements are ok or need to be change, befor we have to reheat power ic at last , greatings from TAHSEEN TEAM EGYPT
bold text
My phone (Galaxy S4) displayed the same message although the temperature was close to 30°C (86°F). In addition, the icon “charging” appeared although the device was not connected to a charger. I opened it, discovered some traces of water (realizing that the device was actually exposed to some water earlier during the day), carefully wiped water droplets and let it dry overnight. On the next morning, the problem was fixed.
OK guys changed my charging port got the similar error (low temp) the ribbon connection was loose , when in stalling the connections are treated with a little too much care I pressed hard on connections and problem was solved .
Hello Austin Harris , i have fix this fault few times and its very simple repair to do. Hereyou can find USB board replacement guide, here you can find required part (Samsung Galaxy S4 Charging Assembly) Cheers!
motherboard problem..should be replace new motherboard then will be ok soon ! good luck !
re solder battery connecter and chenge charging strip…
http://forum.xda-developers.com/showthre…
No its not damaged. i had the same problem /message .open up the phone and pull the sim card ,sd card and remove the mid frame. Just above the usb charge connector you will see two small gold contacts that touch what i believe is the temp sensor which is located in the mid frame assembly.Clean the two contacts on that sensor with a q tip dampened with rubbing alcohol.You may also have to be careful and slightly bend upward those two springy contacts that touch the temp sensor. Hope this works for you it fixed my S4.
Hi friend,I think the usb charging flex cable is damaged during screen replacement. Maybe you need replace the flex cable.
Just change the USB charge flex, problem solved.
Turn off your phone when charging it
I am having the same trouble with my lenovo k3 note ,its not a big matter as everyone said…I fixed this problem my self in a few min..Probably phones with li-on batteries are having such problems. I will tell you the steps which I had followed to fix my phone
- I removed the battery first and Make the phone and battery alittle warmer by using a cotton(even a blanket)
- After that I placed my phone in a blanket which will make the phone warm for a while. 3.And I used a multi charger to charge the battery directly for about 30 min..The I switch on the device ,then I found 3% charge on the device ,first I thought the problem is didn’t solved yet…. Then I charged the phone using a charger and used it for while during charging… Now I am not finding any “low battery heat issues”… Its works fine…Try out these guys..I hope it will work for you too..
I for one pulled the back near the port, let air pass through it since I had recently replaced the port like a few months back. Then it started charging, I think maybe at times sweat can build up or by whatever means, liquid happens to just get inside the electronic components.
