Chosen Solution
I recently switched out the LED’s I made sure to apply a decent amount of flux as well as making sure all nothing apart from the original LED’s were removed when I applied the new LED’s and soldered them again 3 out of 4 did not work so I fixed the soldering there and now none of the lights will come on nothing is burned on the board and all original pieces of the board are in place besides the replaced LED’s The RF board does the usual noise when you turn it on, the controller sync’s and the eject sensor works it is simply not showing any lights.
I cleaned the board with some alcohol and once i let it dry i heat treated it and it has seemed to work perfectly. Although I am still curious what part of the board powers the LED’s?
