Posts

Chosen Solution I installed the new battery i got from ifixit. The battery charges & computer runs fine. The only problem i have is that when the power indicator gets to 20%, my laptop shuts down. When I plug in the charger & restart it, it shows the battery at close to 0%. I’ve charged calibrating it twice & it still happens. Any suggestions? The battery you are using might be used already making it seem like is has power when in reality is has very little power....

Chosen Solution I currently have a 15’ MBP that needs a logic board(820-3787), however i was sent the wrong one(820-3662). While it fits, i used one i had to test laying around (same Part number) once powered on the fuse for the LCD blew. Before sending in to get the fuse fixed i was wondering if it was a compatibility issue or maybe a bad cable on the LCD? Old LB#is 820-3787 and the test board i ruined is a 820-3662-a any help would be greatly appreciated!...

Chosen Solution what is procedure to correctly reinstall miele upright cord rewinder with tension In order to access the cord on the Miele S183 upright, you’ll need to first remove the handle from the vacuum cleaner. There is a large screw that holds the handle in place that is located under neath of the lower cord wrap hook. Simply remove this screw, and slide the off the vacuum by pushing the handle towards the back of the machine....

Chosen Solution I have a Sound Touch 30 audio system, I opened the front panel to clean the dust when I was trying to open the cable between motherboard to display screen connected ribbon cable got damaged. because of cable damaged my front panel display is not working (cable details AWM 20861 105C 60V VW-1). How do i get a new cable so that i’ll fix it myself?

Chosen Solution S5 green/yellow-ish flickering screen at low brightness Hi there! I’ve been experiencing some issues with my Samsung S5 screen recently. Basically, when I turn brightness down very low, around 7/8ths of the screen shows this greenish flicker. I can still see what’s on the screen but it just has a rapid green flicker superimposed. It’s not an issue when I have normal brightness set. Furthermore, when I press the lock button to lock the phone, the screen also flickers green before it goes black....

Chosen Solution Both the water dispenser and ice thermostat quit working over a short period of time. I replaced the ice maker, which solved the ice dumping issue, but I can’t figure out the water dispenser. Good water pressure on incoming lines, I replaced the water valve and have cleared the lines from valve to door, and can hear the water dispenser making noise when pressed. Would it be a bad relay somewhere that’s not allowing the water valve to open?...

Chosen Solution so I just repaired a b500 I got for cheap and after putting the new LCD in i noticed its all black nothing shows up all I hear is the sounds the menu doesn’t show either I put the old one in and the same thing even though it worked before I heard Nikon has like auto-off after an LCD repair but I don’t know how to turn the LCD on any advice would help...

Chosen Solution My samsung a5 fell out of my pocket and hit the floor there is no crack in the screen but its just black …i tried to do all the reset options but nothing is working . It still controls my blurtooth speaker and i hear notification sounds ..what do i do? Hi, As a DIY repair the only thing to do now is to open the phone and first inspect the LCD flex cable connection to the systemboard to ensure that it is secure and hasn’t been jarred loose by the fall....

Chosen Solution My settings screen has a thick white line through the middle of the screen. The settings text is upside down and also reversed. Can this be repaired. settings need to be changed tried to this but it does not work.

Chosen Solution Hi, I’ve replaced the battery of my iPhone 5 but now I’m experimenting some issues with the display. It presents several shadows (see pic) expecially: when I use the notification center, so when the display shows the dark semi-transparent background below dark text and icons (for example the airplane mode icon) Had someone the same problem? Is it a display fault, or connectors, or other? It’s usually the ribbon cables coming from the screen going bad....

Chosen Solution specific r&r sequence for replacement of alternator. top down? bottom up? items to be removed https://www.youtube.com/watch?v=5-9fVRJg… Here are the steps for alternator replacement of BMW X5 Remove the drain plug on the driver’s side bottom of the radiatorDrain the coolant and remove the coolant hosesLoose the belt tensionerUnhook the battery +/- connectionsUnbolt and remove old alternatorTake the wires off the new alternatorClean area where alternator goes, bolt the new alternator insideReattach coolant hoses and refill system with coolant Put the intake tube and duct back on....

Chosen Solution Hello everybody! I have a 4s 32gb with this problem: when I turn it off (holding on-off and sliding on “turn off”), it reboots itself immediately after. The problem doesn’t occur when the iPhone is connected to the pc. Why? I’ve already tried to replace the battery, but the problem persists. I’ve also tried to reinitialize in DFU mode, withouts results. Do you know what it can be? Battery connector, charging connector, on-off button…....

Chosen Solution Hello world, I am looking to understand the schematic here: I recently soldered the very known c7771 capacitor for bad voltage and now i see that on the exact other side of the board i have no U7871, but on the schematic it is written “U7871 IS TO REPLACE U7870” on page 67; but on openboardview it seems like there is a component. Does somebody know if there is a component here or not?...

Chosen Solution Hi, I lost one of the plastic feet of the Trackpad. It is unbalanced now and the click won’t work on the side of the missing foot. Thanks, Yaron You can purchase felt or plastic ‘bumpers’ at most local hardware stores. Buy a size large enough to match or exceed the other foot. You’ll have spares should it happen again. If this Answer is helpful please remember to return and mark it Accepted....

Chosen Solution I have a 2005 Kia Optima LX and I ran out of gas on the side of the highway I’ve in had someone bring me some gas so I thought that was the problem it wouldn’t start so then it acted like the battery and I went out and bought a brand new battery and put it in it that helped but it still won’t start.I put more gas in it and two quarts of oil and it just had....

Chosen Solution 2011 T5S 49 cc 4 cycle gas powered scooter trys to take off when i start it but it has no manual clutch or gear. why is it doing this? That’s just how they are. the second that motor starts it starts turning that wheel you just need to hold the brake. Or reduce the idle ill bet it has clutch like a chain saw turn the idle down on the carb a bit tryit then try it again...

Chosen Solution Hi all, Thanks for wonderful resource Hope you’re well I know I’m not supposed to but I did it anyway and (forcably) removed the trackpad setting screw (i.e. the magnetic screw which, I assume, helps depress the trackpad and register clicks) and in the process I’ve cammed out the screw and possibly ruined the thread which is part of the top case Thankfully I’ve managed to source a couple of new screws: one in case I cam it out again attempting to put it back in and two so I have a spare once I know what I’m contending with....

Chosen Solution IMac turns on, get the charm sound but screen does not turn on, had a look at the motherboard all 4 leds are on. Also did a pram reset. Any ideas please. That focus us to the backlight logic on your logic board or the displays power cable and connection. Review Step 19 here iMac Intel 21.5" EMC 2544 Display Replacement to check the cables connection. If that is good and the cable is as well thant points to the logic board, review Step 23 in iMac Intel 21....

Chosen Solution Is there anyone noticed that the response of the return key of the butterfly keyboard in 13 inch MacBook Pro with Touch Bar version is not strong enough compare with the other key. The click sound sound and the bouncing resposne while you press on it is quit weak. It feels bad. Is there anyway to fix it ? You’ll need to go to an Apple Stop or authorized service center to get your keyboard replaced under the extended warranty problem thats on going Keyboard Service Program for MacBook, MacBook Air, and MacBook Pro These keyboard can’t be fixed like the older scissor keys....

Chosen Solution Why will the Rinse light stays on and washer will not start ? Cause 1 Lid Switch Assembly The lid switch assembly prevents the washer from spinning when the lid is open. If the lid switch assembly fails, the washer may stop mid-cycle. To determine if the lid switch assembly is defective, use a multimeter to test each of the lid switches for continuity. If a lid switch does not have continuity, replace it....