Chosen Solution The screen of my Amazfit Bip just fell off. I removed the old adhesive strip and tried a small bead of clear silicone seal. This didn’t work. What can I use to reattach the screen? I used B7000 glue for mine, it works good for stuff like this. Although for me it still fell off again after several month :) I fixed it again, but in the end I just upgrade to Amazfit BIP 2 recently....
Chosen Solution Went to bed laptop fine woke up to this. Well after powering on and on it got worse. HELP lenovo ideapad 300 17isk Not sure why it happened, but you have a cracked screen. Your only option is to replace the screen. You have this question posted under the category of a Lenovo laptop. Please pot the exact model numberand we shouldbe able to provide you with a few options....
Chosen Solution I was getting battery error messages any time the power adapter wasn’t plugged in. State of charge was stuck at 1% or went from 100% to 1% soon after the adapter was unplugged. The battery preferences tab said that it needed service. So I ordered up the iFixit replacement kit. Step one: drain the old battery. Well, darn if it didn’t run for nine hours of writing, browsing and reading on “1% charge....
Chosen Solution The glass on my iphone 5 is coming off, went to remove the LCD to see if it was the battery swelling to cause this. When i removed the LCD the shield plate stayed in the phone. Not on the LCD like the photos show. How can i get this out with out damaging anything, i used the pry tools, but it wont budge and the tool looks like it may break....
Chosen Solution I just bought a surface 2 last night and there is an issue, I plug in the power cable, but when I see the battery indicator, it shows “plugged in, not charging”. The tablet turns off if I unplug the power cable.. I’ve tried the following workarounds that I found online: shut down the tablet, unplug the power cable and leave it for few minutes, plug in back the power cable and let it charge for few minutes, turn it on....
Chosen Solution the fuel pump works and it has new injectors Oskar this is what i got from the manual. Again this could just be a start since it is a broad error. Test the fuel pump control unit. -Disconnect fuel module with test light and ignition “On”, probe connector “C” to ground Circuit it OK if light is ON. There is an open if light is " OFF. Probe Connector terminal “C” to “D” with test light....
Chosen Solution Rear Brake light out and both brake a front blinkers work on and off with the light flickering fast when it does work. Help OhhhK. When your indicators flash fast, usually that means that one has blown or has a fault. Or it could be your indicator relay. If the rear brake light is out and it isn’t the bulb, then it can only either be a fuse, relay or wiring....
Chosen Solution how to open rear life gate , nothing works manual electrical lift gate now is fixed HAD A PIECE OF CLOTH IN LATCH, used small screw driver to remove thanks I see you already answered your question, but I’ve noticed rust at the top of the liftgate strut on my 2007. I cleaned the thick, rubber protectant pad o-ring by sliding it down and cleaned debris behind it. I scraped it off with triple steel wool, wiped the muck clean, and put a layer of white lithium grease and it opens and closes without jerky jamming issue anymore....
Chosen Solution Red light blinks ten times. Appreciate any help. This is what I have for most of the Panasonic TV’s (need your model number to be more specific) If any of the SUB or MAIN voltages that are highlighted on the DG Board is missing, the unit goes into shutdown. The power LED blinks ten times. If any of the voltages created on the PA Board is excessive or shorted, the unit goes into shut-down....
Chosen Solution I just replaced my iphone 5c screen and now there are little squares all over the screen and it doesn’t register touch at all….. what do i do Recheck you have the cable connected proporly if so and there are still dead spots then it’s a faulty screen or you have damaged the touch cable all so check if you have damaged any pins on the motherboard when connecting the digitizer
Chosen Solution Could I use a hard drive from a PlayStation 3 to replace the hard drive in a Acer aspire R3 laptop? They both use 2.5 inch HDDs, so in theory, yes it should work. It depends on the condition of the PS3’s drive though, you might be better off just buying a new one.
Chosen Solution I do a reset, not working I downgrade the firmware to 4.4.2, not working Re-install the 5.0 lollilop, not working So, what i can do else? i heard that possibly it can be the MotherBoard. Mine did the same thing and when I took it to best buy they said it was the battery, and sure enough when I popped a new battery in it fired right up and ran flawlessly...
Chosen Solution I had tried a lot of methods I’ve read, for example the ones where I need to remove the battery and hold the power button for several seconds, even minutes, also the F2 + power button and there’s still no response. I was able to connected to my TV. I read somewhere about going to system manager and deactivate the intel graphics. I did that and then i activated them again and I was able to see both screens....
Chosen Solution Okay so I cracked my surface pro 4 screen a while back and just now got around to replacing the screen. I successfully removed the old screen and all of the glass and took off the n-trig board. I even took off the ribbon cables from the screen and the motherboard and set them aside. I picked up the new screen and reattached the n-trig board to the new screen....
Chosen Solution My phone got un the sea and my sim card reader isnt functioning Hi, As you know water, electronics and electricity are not a good mix. The impurities in the water causes corrosion and provides circuit paths for the electricity which were not in the phone’s operating design and could damage the components. The corrosion starts immediately and is ongoing until it has been properly cleaned away. First do not try to turn on or charge your phone and then remove the battery as soon as possible from the phone to minimize any further damage....
Chosen Solution Сидел, работал в Visual Studio потом резко белый экран, выключил аварийно. Включил папка с вопросом, иногда зачеркнутый круг. Восстановить через утилиту не вышло. Записал через винду Mojave на флешку перечеркнутый круг. Was working in Visual Studio this Saturday, then abruptly got a white screen, I turned off the system. I then turned the system back on and got a folder with the question mark, Sometimes I get a crossed out circle if I try restarting again....
Chosen Solution Hello. my motorcycle are after crash. soo im trying to repair it. Motorcycle is suzuki gsxr 750cc 2003 years. soo i wanna ask few question`s. are full front suspension forks with wheel from suzuki gsxr 1000 k3 will fit in my 750cc k3 motorcycle ? are plastic for suzuki gsxr 1000 k3 will fit on my suzuki gsxr 750cc k3 ? Thanks for answering. Simon, go to the attached links to find out about the interchangeability of your Suzuki gsxr 750 cc parts with other Suzuki gsxr 1000 k3 and do not be afraid to do a google search your self a lot of forums talk about the interchangeability of the parts....
Chosen Solution My traction control and abs lights just turned on . When I try to accelerate it seems ask if the car dosen’t want to accelerate . Hi @tracem77 , What is the year and model of the vehicle? Get the vehicle’s ODBII port scanned with a scantool, to see what, if any, error codes are being shown. This will give a better idea of what the problem is. If you are in the USA, AutoZone will do this for free, apparently
Chosen Solution hello, love the site, I have ordered 2gb of ram and see where my machine can run up to 3gb of ram. I currently have 1 gb of ram that it came with installed, is it as simple as adding the new ram to a open slot if thats the case? I have not opened the unit yet because i lack the proper tools. Thank you so much....
Chosen Solution Any help with my Whirlpool freezer? I have drinking water dispensing from front however no water making it into ice tray. Replaced icemaker, filter and water intake valve. No blockage in line to ice maker. What can be causing the problem? Whirlpool refrigerator model #WRS325FDAM01 It has one water intake valve in the rear of the unit that I replaced with Whirpool # WPW10179146. One line for the water dispenser in the front (which works fine) and one line for the ice maker (not working) Not sure how to check for power to the water intake valve....
