Posts

Chosen Solution I have a 50’ vizio E500DA0 and it turns on and shows the logo and then blacks out and goes to a grey screen. Hi, Do you get any picture if you press the menu button on the remote? If so what is the source of your video - antenna, HDMI etc? If it is antenna try rescanning for your channels. If you do not get a menu appearing when you press the menu button, try switching off the TV, then the power outlet to the TV and disconnecting the power cord from the outlet....

Chosen Solution The system was rather cool but not cold like it was suppose to. I added some freon into the system and it didn’t get colder, so I added another on and still, not cold. The compressor keeps turning on and off repeatedly. What could be the problem? Thanks you —Oortism Check for leaks. The repeatedly turning on and off is usually caused by not enough refrigerant in the system....

Chosen Solution When it’s 100 degrees outside I just could no longer put my clothes in an electric dryer so I got a clothes line. Only problem seems to be that they are stiff when dried and the towels are scratchy (like a cheap motel). I am using the same Tide detergent and Downey fabric treatment like always. What do I need to change? Justification for why this is repair-related: Drying clothes outside reduces wear on them, make them last longer....

Chosen Solution If i let my note 3 on the table from a small height the cell phone restart itself and the percentage drops. I already change the battery but it still does that. Hai bro same problem in my galaxy note 3 sm n9005 i downloded original os website sammobile.com you can downloded and install your problem is solved bro

Chosen Solution Need Repair guide for replacing the broken wire of the Apple MagSafe2 Power Adapter & is there any good quality cable available for replacement ? MacBook Power Cord 5-Pin MagSafe Connector and Cable Replacement Be very careful! I personally don’t recommend replacing the cord. The reason is not opening the brick, but the cord you are getting is likely not the correct one! Apple was sneaky! The MagSafe connector head has some logic in it besides the bi-colored LED Teardown and exploration of Apple’s Magsafe connector As all of the cords look exactly the same you just don’t know what you are getting!...

Chosen Solution I accidently dropped my hard drive and now it just makes a screeching sound and is not recognized by CPU. Can the data be recovered? Hello There, Make sure after dropping your hard drive, the inside parts are safe. Is it detected by the system if not then data recovery software will not help you to recover your data. So i will suggest you to get and data recovery expert advise....

Chosen Solution I am looking for a referral for someone who can replace an HDMI cable end. I am located in West Palm Beach FL area. (Please see links below for description) https://www.amazon.com/dp/B08797WT7R/ref… https://www.youtube.com/watch?v=Xub0l9s8…|video Hi @elmo1234 , Hopefully there is enough slack in the cable to allow for a new connector to be wired in. Here’s a video that shows how to wire a HDMI connector that may help. It also may depend on what type of HDMI connector is being used....

Chosen Solution My Mac Min won’t boot, getting a flashing ? This is now the 2nd time the hard drive has failed. The first time I had Apple repair it, they replaced the HD with new/same model. So It seems better to just replace with an SSD then have Apple repair with slow crappy HD? I would like to do this upgrade myself. My hard drive was not backed up and I want to salvage anything I can....

Chosen Solution Hi, I’ve seen a couple of answers on here about removing and replacing the keycaps. I spilt lemonade on my keyboard - luckily all the keys still worked but they were sticky. I decided to remove the keys, clean the keys with water and the switches with alcohol. The small letter keys are easy to remove and replace, but the larger keys (command, control etc) with the metal bars, I just can’t seem to get back on - when I try the keys get stuck all the way down....

Chosen Solution Getting green flashing light from charging adapter and battery is not charging, reintalled old battery and still having same issue. All connections look fine. Have you tried a different charging adapter? Just because the connections look fine doesn’t mean they are fine. The MagSafe connectors are magnetized; there can be metallic debris stuck on the connectors. There can also be nonmetallic dirt/grease etc. on the connectors, and it may interfere with the electrical connection....

Chosen Solution I replaced the full assembly screen on iPhone 7plus and all is good except the front and rear camera are black but it does have all the icons and will navigate through each one but just black. The earpiece is also not working. What gives? Help! So am I correct in assuming that everything was working 100% before you started this project? As far as I am aware, there is, no relationship between the icons being available and/or damage to the hardware....

Chosen Solution I have lost the small rubber dust cover that covers the charging port on my Polar M400 watch and would like to purchase a new one. Are they available? Huw, later versions of the M400 removed the dust cover as it hindered the drying out of the charging port, so I don’t think you need to replace it. The charging port is problematic and mine has now broken. The newer model M430 has a more robust charging port....

Chosen Solution Good evening. I recently bought an SSD. I wanted to replace my old HDD on my notebook with this SSD, but at the same time I wanted to use the HDD by adding it via Caddy (adapter that replaces the dvd player with a disk). Any suggestions on how to operate? Take out the HDD: Acer Aspire E5-573G Hard Drive Replacement Put new SSD in its place. Remove Optical/DVD drive or the dummy: Acer Aspire E5-573G Optical Drive Replacement Fit HHD to caddy and slide into optical drive space....

Chosen Solution Needreset my Acer Aspire Password Can’t get my Windows 10 back on help you need a bootable dvd or cd check this link: https://www.top-password.com/knowledge/r…

Chosen Solution Is there any possibility to revive a motherboard? Im not quite sure if it really is but i plugged a portable paper shredder last night and my laptop immediately shut off. I didnt notice anything wrong except this morning, there is a faint smell of burning plastic coming from the exhaust holes, laptop wont turn on and wont charge. ( led lights are dead) Specs: Built in battery...

Chosen Solution My iPhone 6 has started creaking when pressed on the left hand side. Seems to be worst around the level of the volume buttons. I think the screen is possibly loose in the case slightly? Is there an easy fix for this as phone is out of warranty so not sure if genius bar would be much help. Thanks You might have a slight bend in the phone and thats why it is pooping up....

Chosen Solution My sons 3ds charges, and the screens both come on. I am able to click on the sd folders….they register as empty. Then if I try and touch any other icon (settings, web, camera) the game freezes? Can anyone one give suggestions? Same thing happened to me after I fixed my 3ds from black screen of death ( move the wifi card around ) the screen comes on but I can’t load any applications camera, Nintendo sound ect....

Chosen Solution I’ve opened up the back, disconnected the battery, and let it air dry for about a week. I put it back together briefly to check it. When I turn it on the keyboard and power button lights up but the screen stays black. Is there any way to try and fix this? Is it something with the motherboard? Should I replace the screen? Hi @kath8fish When the laptop has been turned on do you get the Windows startup sound, indicating that it has booted into Windows?...

Chosen Solution I have an lg envoy III and I fell into the river with it in my phone….I took out the battery right away and put it in rice. It turns on and works I can receive phone calls but I cannot see my inside screen it’s there anyway to fix that without getting a new phone @brookemichele great that you removed the battery. Rice does not work it does not do anything....

Chosen Solution I did a screen replacement on an iPhone X. Everthing seems fine. No error message, but when I try to configure the face id it will not lock. The face shows, but it does not move on to the next step. Any idea what is wrong? First reset the face id setup to default.Many reason for that by seeing the history might be that cause dust on Dot project....