Chosen Solution Hi, i bought an iphone to have a play with and inside was butchered, managed to get most sorted however the sim reader was removed and looks like a trace went with it. It has five of the six contacts on the logic board but one is black. any way of fixing this? Many thanks Do you see any copper at all? There is usually a small pin hole that is in the middle of all that black....
Chosen Solution Подскажите, пожалуйста, возможно ли починить Apple Pencil 1-го поколения? Когда вставляю iPad появляется уведомление, что заряда очень мало. Хотя до этого Apple Pencil заряжался в течении часа. Если подключаться по Bluetooth подключение скачет постоянно. Apple Pencil connection unstable, not charging. Can you please tell me if it is possible to fix the 1st generation Apple Pencil? When I insert the iPad, a notification appears that the charge is very low....
Chosen Solution A few months ago, my screen shattered and I decided to replace it by myself. I bought everything and all the right tools. I was able to replace the lcd and screen and the phone was brand new again, apart from the fact that the body of the iPhone was a little bent. However, the phone worked perfectly. Yesterday I dropped my iPhone from waist height and it was nothing major....
Chosen Solution I was just getting of the sticky thing that holds the battery in place when I suddenly saw a little rubber thing on the table where I was sitting. I don’t know what it is, but I’m sure that it belongs to the iPhone SE. Does anybody know what this is??? (picture below) That black rubber gasket piece sits on this part here: For clarifying: The rubber part with the hole should sit on top of the purple / pink square part which if I’m correct the pink part on the front camera assembly is the ambient light sensor for sensing the amount of light for auto brightness....
Chosen Solution I have an A50 that started claiming that it was overheating and wouldn’t charge. I tried: Factory reset - No change Clean charging port with pin, IPA, q-tip - No change Remove rear cover - Minor water damage on some chips on charging daughterboard, and on the main board. Replace midframe - No change Shorting the 2 pins on the side of the motherboard that corresponds to the power button sometimes lets the phone turn on depending on what is connected....
Chosen Solution I need to replace the sd/sim card board on my S4, so where would I find a suitable tape to reattach it to the motherboard? When you buy one they usually come with adhesive already on them. If it doesn’t which will probably never happen, you can buy 3M double sided tape (It’s a black color) to use to stick it onto the logic board.
Chosen Solution After restore not open my Phone This is not a very descriptive question but for the benefit of others who may find this Q&A, I will say that if you phone is not working properly after a Restore, consider doing a Hard Reset (hold the Home & Power Button simultaneously for ~10 secs) to see if that will help.
Chosen Solution I have a. a really battered iPhone with broken screen but big memory and decent battery. b. A second one with nice screen and case but less memory and poor battery. both iPhone SE 2016 which’s bits of a should I transfer into the case of b??? And am I thinking the right way here??!! Thank you I would transfer the battery and logic board of iPhone 1 into iPhone 2....
Chosen Solution why I can’t get clear print from laptop iFixit does not do repairs. That try to provide guides and this answer forum to help people fix their own machines. They do sell repair tools and parts for Macintosh and several lines of mobil phones. This forum is manned by individuals, rather than iFixit employees who try to provide solutions for repair problems. Do you get a clear print job from a desktop?...
Chosen Solution So, I have determined that the 500W power supply in my A1862 iMac Pro is bad. Any suggestions on reliable and trustworthy places to purchase a new power supply? Here’s one source I use. Sadly, they are out of stock presently: iMac Pro Power Supply 370W, Apple P/N 661-08944
Chosen Solution The circuit board wires popped and need to be reattached but we don’t know what color goes where Update (09/08/2021) Not sure if you still need this…I don’t have the diagram but I do have one that’s complete that I took a picture of. Hope this helps. Maybe you can help me. I took mine apart and there is a blue wire with a plug that goes to nothing?...
Chosen Solution Hi, Last week I replaced the battery on my iPhone 5 by following the guide and did not have any issues at the time. I am now finding that my rear camera does not autofocus on close up objects. I have already opened the device and reattached the 3 cables at the top (digitiser etc.) to see if this made any difference but it has not. I have also tried tapping and banging the phone as directed elsewhere on this site but again no joy....
Chosen Solution I have a burning question. When I went to get a screen protector applied on my Samsung Galaxy S9+, the guy applied lighter flame for a couple of seconds to the edges of the protector while it was sitting on the screen, presumably in order to make it warmer for easier application. My question is, is it possible the screen and/or the oleophobic coating has been damaged because of this....
Chosen Solution Hi… Replaced battery recently, but glue not sticking completely. I’ve opened the case up multiple times in the last month or so since I replaced it & have to constantly press down the battery to make sure it’s in place. Often when I pick up my laptop can hear the battery shift inside too. Has anyone ever experienced t b is? Did I get a faulty replacement battery with not enough glue?...
Chosen Solution Hi I recently replaced the charging port in my Note 3 N900T. The seller I purchased the replacement from ended up being one for the AT&T version but I’ve read that they are compatible. Once I replaced the part I tried to charge it and the phone is still charging very slowly and the same problems exist from before I replaced it including the phone keeps getting disconnected from the USB cable when it’s plugged in requiring me to fidget with the power cord to get it to start charging even after trying multiple USB cables, and also my phone not being recognized at all when connected to a PC after trying multiple PCs as well....
Chosen Solution I recently bought a BETTY4(3ICP4/56/102-2) battery to replace in my Razer Blade 14” (2017). I followed the iFixit guide and managed to have it power on to desktop until it drained (battery arrived almost empty). The battery isn’t charging. I’ve tried refreshing drivers, checking connections, and battery optimisation instructions. I’ve reached out to the seller, but any advice or tips would be great please! Don’t invest any more time in formatting, drivers, or anything else within the O/S until you’ve already ruled out it’s not a software/hardware issue....
Chosen Solution hi all recently replaced my battery with a ifixit kit for my MacBook pro retina 2015. I installed the battery perfectly fine and calibrated it. Charged fully , let it completely die . and then recharge and not used for 5 hours. Are these batteries made to last 3 hours? the brand appears to be simplo which is oem equivalent. Coconutbattery doesn’t indicate any faults. thanks I don’t see any issues with your new battery at this time....
Chosen Solution My monitor was stolen, turning break in at my home, is there anywhere to get replacement monitor? @cj_kintz , I did a quick search for a replacement monitor and found one at the link below. You may also want to try a search for a (Uniden Guardian G955 replacement monitor) for better pricing perhaps. Good luck. I hope this helped you out, if so let me know by pressing the helpful button....
Chosen Solution EN: Hallo! At my Garmin GPSmap 60CSx was leaking out some battery acid which corroded the electrical contacts on the back side cover of the device. The power supply via USB cable still works very well but when trying to run the device via batteries it doesn´t do anything. When calling the service line of Garmin they argued lapidary that the device is too old for them to spend time on it… They told me, i have to buy a new one....
Chosen Solution How can replace power button flex for Xiaomi Mi Note / Pro. I already the parts for replacement. Unfortunately, there is no ifixit guide specifically for that. But this guide should show you most of it: Xiaomi Mi Note Micro USB/Microphone/Virtual Keys light/Vibrator Replacement This non-ifixit video may also be of use: https://www.google.com/url?sa=t&rct=j&q=… Hope this helps!
