Chosen Solution Hi need to know if my tv is dual voltage purchased in Canada shipped to uk input on tv says 110-120v 50/60hz thanks in advance Hi @nizandy Your television is supporting only from 100 V up to 120V, if you want to use this television in the UK, you must order a switching power supply with nominal voltage from output voltage 100 - 240V and input voltage 240(230)V. To confirm that, you must “open” the TV and read reference on the PCBA....
Chosen Solution I have a Samsung UN46H5203AFXZA that the picture/video has recently totally gone out. It has done this before and I was always able to power it on a while (with blank screen AUDIO working), then power it off for a second and power back on and “SMART TV” came up and it worked and everything was fine. It was almost as if something needed to “warm up” before and the picture would be fine after leaving it on in the blank state, audio working, and powering off then right back on....
Chosen Solution my vizio 42" VO420E has a cracked screen and i have no clue where to begin to find the part to replace the screen. i dont even know what part it is when i look it up i get lost. can anyone help? Lord Xombie, cracked screen are a major PITA. It is very expensive to get a new panel. Most of the time, it will cost more that a new TV....
Chosen Solution My LG TV went black. I could hear the sound at first but no more. Now, screen displays vertical blocks of different colours; black, green, red, blue. Model is 39LN540V Hi @zigarious , Is the problem similar to the middle coloured block image shown here in the service manual for the TV? If so the screen will have to be replaced as it cannot be repaired.
Chosen Solution My Canon Digital Rebel is taking pictures that are all black. The mirror is working but the shutter for the sensor is not rising. Is there any way to fix this without sending into Canon for a 210 dollar repair. Thank you. Having read up a little about your problem, it appears that your best bet would be to replace the shutter box. It is available on places like this and here I found a site where someone did a repair like yours at least it gives you an idea what to expect....
Chosen Solution UPD. It turned out to be quite a lengthy question, so I highlighted the key points in bold. The cycles of my original battery began to exceed 1.3k, the capacity dropped to 67.8%, and the operating system began to report that “Service Recommended.” I decided to replace the battery and searched for a local battery dealer (iFixit won’t ship batteries in my area) and tried to find a brand-name battery of some sort....
Chosen Solution I have a 2002 Altima it will crank but won’t start up. I have replaced everything from relays to sensors, and today my husband took off the serpentine belt and it started right up no problem. Put the belt back on and it would crank but wouldn’t start up. What the heck is going on here? I need help I am puzzled and can’t figure out why it’s doing this!...
Chosen Solution I have a 2011 F-150 V8 w/150k mil. I have to replace water pump , also replaced hoses & thermostat . Everything went together well & runs fine . After driving it next day . I notice the coolant fan ( high sp fan, RS) runs all the time After engine get hot. Just curious if anyone had this problem . Hello, Before you heat up your engine, I suggest to remove the terminal hose from which the water return back to the water tank, in general it’s the upper one (see image below), then start the motor and verify if there is a waterflow coming out from the hose, if there is water then your pump works fine otherwise it’s not or something stuck in the water circuit....
Chosen Solution I have a 3DS XL that’s in fairly good condition that I’d like to be able to reuse or resell. Problem is, after a long period of disuse, when I finally charged the battery, I began noticing problems. The charging light will turn off after a period of charging, I’m pretty sure it’s supposed to stay on as long as it’s plugged in, at least that’s how the New 3DS XL works....
Chosen Solution problem after changing the lcd iPhone 8 plus the touch will be less sensitive it works correctly in my hands and if I put it on the table and try the touch will be less sensitive except that if I take it by hand Most often touch related issues after screen replacements are due to bumps on the housing which should ideally be straightened before putting the new screen in place....
Chosen Solution All of sudden, while I was working, my screen got frozen and started showing some rectangular shape boxes with green vertical lines in it. For the first time, when I pressed on power button, it started beeping (3 times or so) continuously. Wait for 3-5 seconds and again started beeping. After half an hour, I again pressed power button. This time it gets boot up and works properly. The Second time when I experienced same rectangular boxes with vertical lines in it, my MacBook got restarted by itself....
Chosen Solution Has anyone been able to remove the glass from the LCD screen on the Galaxy S9? Unless you have the correct machinery it is unlikely that you will be able to safely remove damaged glass and replace it, the best course of action would be to replace the LCD assembly which can be found on the below link. I have a followup: What is the correct equipment to remove the glass from front and back of the Samsung Galaxys?...
Chosen Solution I have just finished replacing the keyboard in my mid-2015 Macbook Pro 15” laptop. All works well but 3 keys down the middle (T G B - upper and lower). I have tried adding in a British keyboard (as seen in other forums) but no joy. I am going to try running diagnostics and see if this turns up anything. Sounds like you got a bad keyboard!Where did you get it?...
Chosen Solution Hi All I have a kindle fire HD 7 2014 and finding it very difficult to source a new touch screen for this model. Any pointers would be appreciated. I posted a link below to a link on this website! LINK: Kindle Fire HD 7" (1st Gen) Screen I hope this helps. Keegan
Chosen Solution I would love to repair my favorite Patagonia GoreTex rain jacket, where can I purchase a replacement Ideal brand 5 DB (grey color) slide? I would contact Patagonia and explain exactly what you are looking for. I’m sure they will be willing to help. https://www.patagonia.com/shop/clothing-…
Chosen Solution I recently bought a Sony Clie PEG-SL10, primarily for the fact that it takes 2 AAA batteries (easy to replace). However when I do replace the batteries the whole unit hard resets. I can’t find a lot of information on the motherboard but there appears to be 4 cells that might be small batteries (or maybe capacitors?) that would keep the memory long enough to swap batteries over. They appear to be soldered in....
Chosen Solution I purchased my samsung s6 edge plus phone about 2 years ago from a store in USA where the phone came factory unlocked. ( the store was no a regular store like walmart etc) . The model on my phone is Samsung G928G and I need to replace the charging port since the pins broke. When browsing on ebay for replacment charging ports I only get the following model options....
Chosen Solution I recently switched out the LED’s I made sure to apply a decent amount of flux as well as making sure all nothing apart from the original LED’s were removed when I applied the new LED’s and soldered them again 3 out of 4 did not work so I fixed the soldering there and now none of the lights will come on nothing is burned on the board and all original pieces of the board are in place besides the replaced LED’s The RF board does the usual noise when you turn it on, the controller sync’s and the eject sensor works it is simply not showing any lights....
Chosen Solution Hello! I have an Galaxy S6 Edge+ that it is totally dead, not responsive on charge, not power on, nothing… just black screen. Can i know which part of my phone is responsabile for this problem? Please i need this. Have you tried connecting your S6 Edge+ to a laptop or PC? If the computer reads it then it could very well be on and just the display is out....
Chosen Solution I have a Samsung S7 that turns off after 1-5 mins of being on, then displays that the battery is empty. After a few seconds it will display that the battery does have charge. This happens even if the charger is plugged in. Is this a problem with the battery or power IC? IT could be a faulty battery but it also may be a faulty charging port
